There is no need to detour to weighbridge any more to check the total weight; so there is no wasted driving time and we can experience fuel and salary savings. There is no penalty for overweight and axle weight, because the truck scale display placed in the cab shows all important data: axle load, total weight and net weight. The driver can check all values at a glance, but the system also sounds an acoustic signal when the permissible axle loads are exceeded, so it cannot be overlooked. It can be used to measure both air-spring and leaf-spring axles. It has data and analogue output so it can be easily integrated into the fleet tracking system. Accurate measurements of truck on-board scales allow you to take advantage of your optimum weight.
Avoidable overweight fines, maximum overweight utilization!
Measurement of axle weight and total weight directly from the cab.
The driver does not have to press buttons or navigate through menus. It is sufficient to stop in a suitable area, release the handbrake and check the travel level.
It can be fitted to almost any truck type, including a tractor truck, a solo car with or without a trailer, and several further variants. It can also be used effectively on buses.
Instant weight data for maximum utilization and avoiding overweight fine. No extra route to the weightbidge.
The measurement data can be transmitted using the existing fleet tracking system and compared to GPS position data.
Scale tickets can be printed on the measurement results if required.
Truck scales in the cab. With suction cup or fixed attachment
The number of levelling valves determines how many sensors must be installed.
An electric "spiral" cable, independent of original wiring, is installed between the trailer and the tractor.
The high-precision pressure sensor is connected to the air duct of the air springs.
High speed thermal paper printing, a durable solution that is less sensitive to dust and other dirt than a needle matrix printer. Changing the paper is easy and does not require adjustment. The paper cover can be opened with the touch of a button; it is a durable solution.
Using high-precision pressure transmitters and 32-bit sampling, measurement accuracy is limited only by the limitations of the measurement method. Accuracy is below 1%.
An easy-to-read display, where all relevant data is displayed at the same time and which makes drivers' lives very easy. No need to press buttons, because everything is readable instantly.
The scales will make an audible warning sound to the driver when the permissible axle weights and total weights are exceeded. The acoustic signal can be acknowledged or it switches off automatically when the overload is removed.
The system can store calibration settings for multiple trailers, so changing trailers is easy. It is sufficient for the driver to select the current trailer only by the license plate number.
The measurement is based on the pressure of the air springs or the deformation of the mechanical suspension. Signals from the sensors go through the wires to the booth, by this increasing reliability.
Display mounted in the cabin, optionally connected to a printer or fleet tracking.
Measures the air spring pressure of the drive axle
Measures the air spring pressure of the group axle.
The spiral connection cable transmits the electrical signal to the tractor. The assembly remains detachable.